NJM9 is suitable for processing miter edge, bottom edge and arrise
on glass piece with different size and thickness. Miter spindle and
front arise spindle are moving along with the front beam, so it is
very easy to adjust miter angle and processing thickness. The miter
edge and bottom edge are as bright as original after processing.
1.Front beam is electrical controlled.
2.Input and output conveyors adopt timing belt which can improve
the stability of transmission. And the timing belt is easy to
replace during maintaining.
3.Water tank is stainless steel.
4.A special design of the input and output section for controlling
the grinding amount of glass without adjusting each spindle
5.Front beam and rear beam are processed by CNC processing center.
6.Brand of low-voltage electrical apparatus is Schneider.
7.Miter angle, thickness, and remaining thickness are showed and
adjusted by digital display or PLC.
1.Processing glass thickness: 3-25mm
2.Miter angle:0°-60°(It means angle on glass is 30°-90°)
3.Min. processing size:80mm×80mm
4.Spindle quantity: 9
6.Installation power: 20.3KW
7.Occupation land: 7.8m(length)×1.4m(width)×2.5m(height)